Intelix FLX-88 Manual do Utilizador descarregar pdf (Página 13)

FLX-88 Installation Guide

3. Slide the I/O card between the guide rails until it is firmly seated.

4. Secure the I/O card by tightening the thumb screws.

5. Connect the appropriate cabling to the I/O card.

6. Power on the matrix.

FLX-BI4 and FLX-BO4A Wiring

A compatible HDBaseT with control transmitter or receiver is required to pass the control signals

to the source or display devices.

To connect the FLX-BI4 to a compatible transmitter or the FLX-BO4A to a compatible receiver, a

Cat 6 or greater cable with a TIA-568B crimp termination on the RJ45 connector must be used.

The Cat 6 cable must not exceed 40 meters for 3D content. The Cat 6 cable must not exceed 70

meters for 2D content.

To use the IR extension capabilities of the FLX-BI4, the DIGIB-EYE (wideband IR receiver) and

DIGIB-EMT (wideband IR emitter) will need to be connected to the appropriate IR ports. These

parts are not included with the HDBaseT I/O cards.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Sem comentários

Intelix FLX-88 Manual do Utilizador Página 13